Difference between revisions of "The heat budget of tidal flats"

From Coastal Wiki
Jump to: navigation, search
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
 
[[Image:Onken_1.jpg|thumb|left|'''Figure 1''':In the Hörnum tidal basin, time series are available from a bottom mounted acoustic current profiler (bADCP) and a measuring pile. Ship's tracks of the volume flux calibrations are indicated by red lines.]]
 
[[Image:Onken_1.jpg|thumb|left|'''Figure 1''':In the Hörnum tidal basin, time series are available from a bottom mounted acoustic current profiler (bADCP) and a measuring pile. Ship's tracks of the volume flux calibrations are indicated by red lines.]]
 
===Introduction===
 
===Introduction===
A major objective of the research programme is to develop methods to monitor and quantify  exchange processes between the Wadden Sea and the North Sea. The generic approach is to acquire high-frequency time series of basic physical quantities at choke points, i.e. in tidal inlets or tidal channels, to evaluate the present horizontal fluxes of heat, freshwater or suspended particulate matter (SPM), and then to integrate the fluxes between two consecutive low tides. This yields the tidal budget of the corresponding quantity for the upstream area. An intrinsic problem of this method is to interprete the measurements at the choke points in terms of volume fluxes being representative for the entire inlet or channel, respectively. Here, the whole method is exemplified for heat fluxes (Fig. 2).
+
A major objective of the research programme is to develop methods to monitor and quantify  exchange processes between the Wadden Sea and the North Sea. The generic approach is to acquire high-frequency time series of basic physical quantities at passage points, i.e. in tidal inlets or tidal channels, to evaluate the present horizontal fluxes of heat, freshwater or suspended particulate matter (SPM), and then to integrate the fluxes between two consecutive low tides. This yields the tidal budget of the corresponding quantity for the upstream area. An intrinsic problem of this method is to interprete the measurements at the passage points in terms of volume fluxes being representative for the entire inlet or channel, respectively. Here, the whole method is exemplified for heat fluxes (Fig. 2).
  
 
[[Image:Onken_2.jpg|thumb|right|'''Figure 2''':The heat budget and the bottom heat flux are determined by melding observations with models.]]
 
[[Image:Onken_2.jpg|thumb|right|'''Figure 2''':The heat budget and the bottom heat flux are determined by melding observations with models.]]
Line 19: Line 19:
  
 
===Results and Outlook===
 
===Results and Outlook===
Fig. 5 shows that the budget at the bADCP is negative from April through the middle of August, hence relative to this choke point the upstream tidal flat area is exporting heat. From August the budget becomes positive which means import of heat. At the pile, the situation is reversed: the budget is positive from March through late August (import), and switches to an export situation in autumn. This is because during night time a fraction of the incoming water is releasing heat to the colder tidal flats. The relative contribution of that fraction being in contact with the flats is higher at the pile than at the bADCP. This is illustrated in Fig. 6. Corresponding evaluations of the mean heat budget for the years 2005 and 2006 show that the budgets exhibit interannual variations but the gross behaviour is similar among those years.
+
Fig. 5 shows that the budget at the bADCP is negative from April through the middle of August, hence relative to this passage point the upstream tidal flat area is exporting heat. From August the budget becomes positive which means import of heat. At the pile, the situation is reversed: the budget is positive from March through late August (import), and switches to an export situation in autumn. This is because during night time a fraction of the incoming water is releasing heat to the colder tidal flats. The relative contribution of that fraction being in contact with the flats is higher at the pile than at the bADCP. This is illustrated in Fig. 6. Corresponding evaluations of the mean heat budget for the years 2005 and 2006 show that the budgets exhibit interannual variations but the gross behaviour is similar among those years.  
Presently, work is in progress to validate the results achieved so far by direct measurements of the sediment temperature of the tidal flats. Further on, the described method is being applied to determine the budgets of freshwater and SPM.
 
  
 
<br/>
 
<br/>
 
<br/>
 
<br/>
 +
 +
 +
==Related articles==
 +
:[[Dynamics and structure of the water and matter ex-change between the Wadden Sea and the German Bight]]
 +
:[[The backbarrier tidal flats in the southern North Sea - A multidisciplinary approach to reveal the main driving forces shaping the system]]
 +
 +
  
 
{{author  
 
{{author  

Latest revision as of 13:29, 22 August 2020

Figure 1:In the Hörnum tidal basin, time series are available from a bottom mounted acoustic current profiler (bADCP) and a measuring pile. Ship's tracks of the volume flux calibrations are indicated by red lines.

Introduction

A major objective of the research programme is to develop methods to monitor and quantify exchange processes between the Wadden Sea and the North Sea. The generic approach is to acquire high-frequency time series of basic physical quantities at passage points, i.e. in tidal inlets or tidal channels, to evaluate the present horizontal fluxes of heat, freshwater or suspended particulate matter (SPM), and then to integrate the fluxes between two consecutive low tides. This yields the tidal budget of the corresponding quantity for the upstream area. An intrinsic problem of this method is to interprete the measurements at the passage points in terms of volume fluxes being representative for the entire inlet or channel, respectively. Here, the whole method is exemplified for heat fluxes (Fig. 2).

Figure 2:The heat budget and the bottom heat flux are determined by melding observations with models.

Methods and Techniques

Time series are available from measuring piles located in the East Frisian Wadden Sea and in the Hörnum tidal basin (see article "Dynamics and structure of the water and matter ex-change between the Wadden Sea and the German Bight"). The observations of the latter pile are complemented by time series from a bottom-mounted acoustic doppler current profiler (bADCP) located about 4 km southwest of the pile in the same tidal channel (Fig. 1); therefore, the above methods have been applied to the Hörnum basin.
Figure 3: Volume flux in the Hörnum Deep vs. the east component of water velocity recorded by a bADCP (red dots). The linear regression is indicated by the blue straight line.
Occasionally, 'representativity campaigns' with a research vessel were conducted close to the time series stations in order to convert the point-measurements of water velocities to volume fluxes in the tidal channel: the vessel is equipped with a downward looking Acoustic Doppler Current Profiler (ADCP), and by back and forth crossing of the channel the volume flux of water is measured directly. The volume flux is then related to the simultaneous velocity records at the bADCP or the pile, respectively (Fig. 3), and the relationship is applied to the entire point velocity time series.
Figure 4: Volume flux, heat flux, and tidal heat budget in the Hörnum Deep, evaluated at the bADCP time series station for early June 2004. The tidal heat budget was integrated between two successive low tides indicated by red dots.

The present heat flux in the channel is proportional to the product of the volume flux and the temperature. Integration of the flux between two successive low tides yields the tidal heat budget. As can be seen from Fig. 4, the tidal budget exhibits oscillations with a doubletidal period, which is related to the diurnal cycle of heating and cooling of the tidal flats. The diurnal cycle, together with the fortnightly inequality, are filtered out by averaging the budget with a running mean over one month The heat budget in the open ocean is solely controlled by advection and the net heat flux between the ocean and the atmosphere. In comparison, the heat budget in tidal flats is additionally impacted by the bottom heat flux between the sea bed and the overlying water column. An analytical model was developed, which in conjunction with a numerical transport model for the determination of the respective catchment area yields estimates of the bottom heat flux in dependency of the tidal heat budgets at the two time series stations. Both for the bADCP and the pile, the heat budget of the respective catchment area was evaluated for the year 2004 between the middle of March and late October, and the bottom heat flux was determined for the same period.

Figure 5: The mean tidal heat budget for the catchment areas of the bADCP and the pile in the Hörnum tidal basin in 2004.
Figure 6: The tidal heat budget of the catchment areas of the bADCP (top panel) and the pile (bottom) as a function of the daynumber and the time of high tide. Red indicates export, blue import of heat.

Results and Outlook

Fig. 5 shows that the budget at the bADCP is negative from April through the middle of August, hence relative to this passage point the upstream tidal flat area is exporting heat. From August the budget becomes positive which means import of heat. At the pile, the situation is reversed: the budget is positive from March through late August (import), and switches to an export situation in autumn. This is because during night time a fraction of the incoming water is releasing heat to the colder tidal flats. The relative contribution of that fraction being in contact with the flats is higher at the pile than at the bADCP. This is illustrated in Fig. 6. Corresponding evaluations of the mean heat budget for the years 2005 and 2006 show that the budgets exhibit interannual variations but the gross behaviour is similar among those years.




Related articles

Dynamics and structure of the water and matter ex-change between the Wadden Sea and the German Bight
The backbarrier tidal flats in the southern North Sea - A multidisciplinary approach to reveal the main driving forces shaping the system


The main author of this article is Onken, Reiner
Please note that others may also have edited the contents of this article.

Citation: Onken, Reiner (2020): The heat budget of tidal flats. Available from http://www.coastalwiki.org/wiki/The_heat_budget_of_tidal_flats [accessed on 24-11-2024]


The main author of this article is Callies, Ulrich
Please note that others may also have edited the contents of this article.

Citation: Callies, Ulrich (2020): The heat budget of tidal flats. Available from http://www.coastalwiki.org/wiki/The_heat_budget_of_tidal_flats [accessed on 24-11-2024]


The main author of this article is Vaessen, Bernd
Please note that others may also have edited the contents of this article.

Citation: Vaessen, Bernd (2020): The heat budget of tidal flats. Available from http://www.coastalwiki.org/wiki/The_heat_budget_of_tidal_flats [accessed on 24-11-2024]


The main author of this article is Riethmueller, Rolf
Please note that others may also have edited the contents of this article.

Citation: Riethmueller, Rolf (2020): The heat budget of tidal flats. Available from http://www.coastalwiki.org/wiki/The_heat_budget_of_tidal_flats [accessed on 24-11-2024]