Statistical description of wave parameters

Because of the random nature of natural waves, a statistical description of the waves is normally always used. The individual wave heights often follow the Rayleigh-distribution. Statistical wave parameters are calculated based on this distribution. The most commonly used variables in coastal engineering are described below.

Most commonly used variables in coastal engineering

Significant wave height

The significant wave height, H_s, is the mean of the highest third of the waves in a time-series of waves representing a certain sea state. This corresponds well with the average height of the highest waves in a wave group. H_s computed on the basis of a spectrum, is referred to as H_m0.

Fig. 1. Time-series of individual waves or surface elevations

Mean wave period

The mean wave period, T_m, is the mean of all wave periods in a time-series representing a certain sea state.

Peak wave period

The peak wave period, T_p, is the wave period with the highest energy. The analysis of the distribution of the wave energy as a function of wave frequency (period^-1) for a time-series of individual waves is referred to as a spectral analysis. Wind wave periods (frequencies) often follow the so-called JONSWAP and Pierson-Moskowitz spectra. The peak wave period is extracted from the spectra. As a rule of thumb the following relation can be used: T_p ~ 5.3 H_m0^1/2.

Mean wave direction

The mean wave direction, θ_m, which is defined as the mean of all the individual wave directions in a time-series representing a certain sea state.

Describing wave conditions

Fig. 2. Wave spectrum: Hm0=1m, T02=3.55s, Tp=5s (corresponding to peak frequency of 0.2 s-1)

These parameters are often calculated from continuous or periodic time-series of the surface elevations; typically the parameters are calculated once every one or three hours, whereby a new discrete time-series of the statistical wave parameters is constructed. This time-series is thereafter analysed statistically to arrive at a condensed description of the wave conditions as follows:

• Wave height distribution represented by H_s vs. percentage of exceedence. This often follows a Weilbull-distribution
• Directional distribution of the wave heights, which is often presented in the form of a wave rose
• Scatter diagram of T_p vs. H_s

Analyses of extreme wave conditions are performed on the basis of max. wave heights in single storm events or on the basis of annual max. wave heights. These analyses are often presented as exceedence probability vs. wave heights.

Fig. 3. Wave height duration exceedence distribution; example from Rødsand, Denmark.

Fig. 4. Wave Rose; example from Malacca Strait.

Fig. 5. Scatter diagram, T_p vs. H_s, Faroe Islands.

Fig. 6. Extreme value analysis of wave height; threshold value = 2 m, Weibull distribution

Further reading

Mangor, Karsten. 2004. “Shoreline Management Guidelines”. DHI Water and Environment, 294pg.

The main author of this article is {{{AuthorFullName}}} Please note that others may also have edited the contents of this article. Citation: {{{AuthorFullName}}} (2007): Statistical description of wave parameters. Available from http://www.coastalwiki.org/wiki/Statistical_description_of_wave_parameters [accessed on 22-11-2024] For other articles by this author see [[:Category:Articles by {{{AuthorFullName}}}]] For an overview of contributions by this author see Special:Contributions/Mangor, Karsten

[[Category:Articles by {{{AuthorFullName}}}]]

return to

Theme 5 Articles