Clean Water Act

From Coastal Wiki
Revision as of 20:54, 7 March 2020 by Dronkers J (talk | contribs)
Jump to: navigation, search

The Clean Water Act (CWA) of 1972 [1] is the overarching federal law for managing surface water quality in the United States. The CWA employs regulatory and non-regulatory tools to reduce point sources of pollutant discharges into waterways, finance municipal wastewater treatment facilities, and manage polluted runoff. The CWA’s goal is to “restore and maintain the chemical, physical and biological integrity of the Nation’s waters” so as to improve “water quality which provides for the protection and propagation of fish, shellfish and wildlife and provides for recreation in and on the water”, wherever attainable. The fundamental purpose of the CWA has been widely communicated as making the nation’s waters “fishable and swimmable”.

Statutory Provisions of the CWA

The CWA includes several major programs and delegations of authority. Below is a summary of the major statutory provisions related to coastal management:

  • NPDES permit program

Covers point sources of pollution discharging into a surface water body.

  • Section 311

Addresses oil spill pollution by providing EPA and the Coast Guard with authority to prevent and respond to oil spills.

  • Section 319

Provides grants to address nonpoint sources of pollution, from sources such as farming and forestry operations

  • Section 404

Gives the US Army Corps of Engineers regulatory power over the placement of dredged or fill materials into wetlands

  • Section 401

Requires federal agencies to obtain certification from the states before issuing permits that would result in increased pollutant loads to a water body.

  • State Revolving Funds (SRF)

Provides sizable federal loans to municipalities to address point and nonpoint sources .

The CWA Signaled a Dramatically Different Approach to Pollution Abatement. The Rivers and Harbors Act of 1899 preceded the CWA as the principle mechanism by which water use permits were issued, including permits to discharge wastes to water bodies. Until 1872 the regulation of discharges to water bodies by the federal government, and by complimentary legislation adopted by individual states, was based on the principle that any limitations to such discharges required a scientifically convincing demonstration that the discharge had an adverse impact on the receiving water body. This science based requirement for cause and effect linkages was very difficult to demonstrate – particularly where multiple sources of pollution were flowing into a polluted water body. There was increasing evidence that this approach was producing increasingly severe water pollution in some areas and was not reducing pollution in others. After many years of debate a consensus emerged that water quality regulation should be based on the universal application of the best available pollution control technology to all discharges. This technology based approach lies at the heart of the CWA. Application of best available technology has been a successful strategy for reducing point sources of pollution. It has been less successful for non-point sources which are not regulated under the CWA.

Water Quality Standards. The first national water quality standards (WQS) were defined in 1965 and applied only to interstate waters – not water bodies that were contained within the boundaries of a single state. The water quality standards specified the uses of a water body and the attainment and maintenance of these uses was to be the basis for regulating discharges. This system proved to be ineffective due to their limitation to interstate waters and a lack of enforcement. Water quality standards continue to be used under the CWA and are used to designate the uses of the water body – recreation, water supply or agriculture - and specify the quantifiable pollutant concentrations to achieve the specified uses. However, under the CWA, these use standards are only used to condition permits after the technology-based standards have been met. If a water body continues to be impaired, permits may be changed based on more stringent WQS that require increased reductions in pollutants.

The Regulation of Point Sources of Water Pollution

The National Pollution Discharge Elimination System (NPDES) is the major mechanism for implementing the CWA. This requires that all industrial and government discharge facilities as well as animal feedlots obtain a permit for discharging pollutants to surface waters. Amendments to the act have added industrial and urban stormwater dischargers to the NPDES. Stringent regulations have been developed to address wet weather point sources like urban storm sewer systems and construction sites. The EPA administers the NPDES in partnership with the states. Forty-five states have been granted the authority by EPA to issue permits.

The Evolution of CWA Strategies. Reducing point source pollutant discharge was the initial focus of the programs developed to implement the CWA with the assumption that control of point sources of pollution would lead to fishable and swimmable waters. Massive amounts of federal funds were directed to the states for construction of publically owned waste water treatment plants and industries had to make large investments in applying the best available treatment technologies to their effluents. Over time it was recognized that nonpoint sources of pollutants are as or more important that point sources. Figure 1 highlights the importance of addressing nonpoint sources of pollutants for various types of waters.

Reduction of Nonpoint Sources of Pollution. Pollutants from nonpoint sources (NPS) include contamination from agriculture and urban stormwater runoff. The NPDES does not address these sources. However, in 1998, EPA reported that NPS were responsible for more than 40 percent of all impaired waters, while only 10 percent was caused by point source discharges [2].

Figure 1. Ranking of Sources Contributing to Water Quality Impairment

In 1987, the EPA through the authority of the CWA created a federal grants program (Section 319) to address nonpoint sources of pollution. This voluntary program encourages states to develop nonpoint source (NPS) management programs. Funds provided to the states for NPS programs are used to create state regulations for NPS and to implement Total Maximum Daily Loads (TMDLs). The federal government has applied only voluntary measures to address NPS.

The Total Maximum Daily Load (TMDL) Strategy. The CWA mandates that if a water body is not meeting WQS through the use of technology-based controls, a means for meeting these standards must be developed. In these instances the most common approach is to produce a ‘pollution budget’ that is the basis for calculating the total Maximum Daily Load (TMDL) that will meet the WQS. TMDLs were not applied during the first two decades of the CWA. While NPDES has been effective in reducing point source discharges, water bodies continue to need a more comprehensive strategy to address all sources, specifically nonpoint. TMDLs or equivalent comprehensive strategies for impaired waters are required by the act. EPA is encouraging states to apply TMDLs at the watershed scale in order to promote efficiencies, holistic analysis and collaboration across states.

The CWA Planning Process

The state-by-state process of implementing the CWA and planning the many activities that are undertaken is an iterative process with defined steps. One version of this process (which includes nonpoint sources) is shown in Figure 1. The progress made by each state is periodically reviewed and priorities for action are revised accordingly.

Figure 2. The Water Quality Based Approach to the CWA [3]

Other Strategies to Reduce Nonpoint Sources. The CWA has drawn upon other programs administered by the EPA to address nonpoint sources of water pollution. These include:

  • The EPA’s watershed planning program that allows the EPA and states to address additional issues beyond the mandate of the CWA and engage citizens in the planning and implementation
  • The National Estuary Program. The CWA was amended in 1987 (Section 320) to establish the National Estuary Program (NEP). This program is designed specifically to improve the water quality of nationally important estuaries. States make a request to EPA to establish an NEP and develop a Comprehensive Conservation and Management Plan. NEPs can make use of TMDLs or other mechanisms to achieve water quality standards. NEPs encourage states to apply a watershed approach to managing and restoring water quality and habitat protection.
  • The Coastal Zone Management Act encourages a voluntary program for comprehensive land and water planning in the coastal zone that is designed specifically to contribute to CWA goals and programs.
  • Voluntary programs such as cost-sharing and education are other methods for addressing nonpoint runoff.

See also

Internal Links

External Links

Further Reading

  • Ryan, Mark. 2004. The Clean Water Act Handbook, Second Edition. American Bar Association
  • Boyd, James. 2000. The New Face of the Clean Water Act: A Critical Review of the EPA’s Proposed TMDL Rules. Discussion Paper 00-12 March 2000

References

  1. ↑ Clean Water Act Legislation http://www.epa.gov/lawsregs/laws/index.html#env
  2. ↑ EPA Watershed Academy Website: Introduction to the Clean Water Act http://www.epa.gov/watertrain/cwa/
  3. ↑ California State Water Quality Control Board. Water Quality Based Approach. Presentation. http://www.swrcb.ca.gov/academy/courses/wqstandards/materials/mod2/02module.pdf


The main authors of this article are Stephen Bloye Olsen and Glenn Ricci
Please note that others may also have edited the contents of this article.
Citation: Stephen Bloye Olsen; Glenn Ricci; (2020): Clean Water Act. Available from http://www.coastalwiki.org/wiki/Clean_Water_Act [accessed on 22-11-2024]
Retrieved from "https://www.coastalwiki.org/w/index.php?title=Clean_Water_Act&oldid=76500"