Computable general equilibrium

Computable general equilibrium (CGE) models are a class of economic models that use actual economic data to estimate how an economy might react to changes in policy, technology or other external factors. The word equilibrium means that values taken by endogenous variables in the model allow the resolution of all equations. CGE models are descended from the input-output models pioneered by Wassily Leontief, but assign a more important role to prices. Thus, where Leontief assumed that, say, a fixed amount of labour was required to produce a ton of iron, a CGE model would normally allow wage levels to (negatively) affect labour demands. One of the main interests of CGE models is their dynamic characteristic enabling to make projections up to 100 years.

The CGE model

A CGE model consists of (a) equations describing model variables and (b) a database (usually very detailed) consistent with the model equations. Data required are the following :

1. Tables of transaction values, showing, for example, the value of coal used by the iron industry (read the section above “Regional economic accounting methods by Input-output matrix”). Usually the database is presented as an Input-output matrix (I-O) or as a social accounting matrix (SAM). In either case, it covers the whole economy of a country (or even the whole world), and distinguishes a number of sectors, commodities, primary factors and perhaps types of household. I-O tables can be taken from Eurostat Manual of Supply, Use and Input-Output Tables, from the national statistic of the studied country or from the governmental (or regional) economic department. For more details on SAM, read Pyatt and Round (1985).
2. Elasticities: dimensionless parameters that capture behavioural response to policy scenarios. For example, export demand elasticities specify by how much export volumes might fall if export prices went up (e.g. due to a tax on green house gas emitted by merchandise transportation). Data on elasticities are usually taken from literature survey (Böhringer, 2004).

Nowadays, CGE models are made of thousands of equations. They can give simulations up to 100 years time horizon and have regional, national and international spatial dimensions. Hecq (2006a) categorized those models by economical mechanisms, and identified four categories described below. They can be divided into two families : "bottom-up" and "top-down".

• Bottom-up models are built on a detailed representation of productive system (supply side) and demand (demand side). Based on data on cost and effectiveness of technologies as well as on basic resources utilization such as energy, they calculate minimum cost strategies. Their weakness stems from the translation of feedback in term of macroeconomic equilibrium.

Example of bottom-up model : Technological optimization models (MARKAL, DNE21+, GMM, MESSAGE,…). They are based on technological data for each sector of a country. They model energetic demand taking into account technical constrains. They allow us to highlight optimal technological options (cost-effectiveness) in order to achieve environmental targets at diverse horizons (e.g. CO₂ emissions).

• Top-down models describe the economic system in a global way through aggregates and their interrelations in the frame of a general equilibrium built on the base of microeconomic theory.

Example of top-down model : Macroeconometric models (NEMESIS, E3MG, HERMES, etc.). They are numerous and are more developed and accurate than the previous models mentioned above. However, they are neo-Keynesians. Therefore, they operate according to the demand in the economy, which is not always in equilibrium with the supply (structural unemployment is possible to take into account in those models). In addition, production functions are stemming from econometric techniques based on historical series that affect their structure.

Practical use of CGE models

Though models are still subject to discussions, they find numerous applications (simulation, prevision, research) among others evaluation of environmental policies impacts such as taxes on CO₂/energy and polluting emissions trading schemes. CGE are relevant when willing to evaluate the economic implications of policy intervention on resource allocation and incomes of agents (for example, a tax on energy and greenhouse gas emissions might affect fuel prices, the consumer price index, and hence perhaps wages and employment). For instance a relevant question to be answered by CGE would be “what is the optimal tax policy to maximize economic performance given minimum constraints on the level of environmental quality or distributional concerns.”

Since CGE are partly based on I-O tables, what is written above in section “regional accounting by matrix Input-output” applies also to CGE. See there for additional information concerning relevancy of CGE.

Limits of the method

CGE models are complex to implement and their results are highly dependent on key economic parameters on which uncertainties remain. In addition, those models are expensive and time consuming (it takes months to years to build a CGE model).

In addition, the model equations tend to be built upon an underlying theory (i.e. traditional economics, as defined by Maréchal and Lazaric, 2010), often assuming cost-minimizing behaviour by producers, average-cost pricing, and household demands based on optimizing behaviour. However, most CGE models conform only loosely to the theoretical general equilibrium paradigm. For example, they may allow for:

1. non-market clearing (general equilibrium is not reached : supply is not equal to demand), especially for labour (unemployment) or for commodities (inventories)
2. imperfect competition (e.g. monopoly pricing)
3. demands not influenced by price (e.g. government demands)
4. a range of taxes
5. externalities, such as pollution

However, even with these corrections to match more the economic reality, Maréchal and Lazaric (2007) estimate that the use of CGE models is highly disputable because of their inadequate account of the real behaviour of economic agents. Indeed, CGE models are built upon a traditional economics that has been strongly questioned by scholars from different fields. For instance, the Homo Oeconomicus paradigm is completely at odds with empirical evidence contained in studies showing that economic decisions are partly guided by feelings and thus emotionally coloured (providing human beings with "intelligent emotions and emotional intelligence"). An individual is not able to make optimal decisions in order to reach its goals. He can only make satisfactory decisions because he is limited by its capacity, its habits and unconscious reflexes; its values and concepts of the goal to reach (which can even be different from the goal decided by the enterprise); and by its knowledge and the imperfect information he has access to. Not grasping this, is a major drawback of CGE models.

Lastly, CGE, similar to I-O tables, are not able to take into account issues with small impacts because of their too high aggregation level.

Other regional economic accounting methods

• Input-output matrix
• Supply chain analysis
• Green accounting

See also

• Multifunctionality and Valuation in coastal zones: concepts, approaches, tools and case studies
• Multifunctionality and Valuation in coastal zones: introduction

References

The main authors of this article are Mateo Cordier and Walter Hecq Please note that others may also have edited the contents of this article. Citation: Mateo Cordier; Walter Hecq; (2019): Computable general equilibrium. Available from http://www.coastalwiki.org/wiki/Computable_general_equilibrium [accessed on 21-11-2024] For other articles by this author see Category:Articles by Mateo Cordier For other articles by this author see Category:Articles by Walter Hecq For an overview of contributions by this author see Special:Contributions/Mcordier For an overview of contributions by this author see Special:Contributions/Walter Hecq